Pentru mai multe produse din oferta noastra va rog sa vizitati site ul dpelectronic.ro

Control nivel lichide cu trei sonde de 1,5 m
Se poate utiliza la rezervoare de apa, bazine, acvarii, piscine pentru controlul nivelului de apa.
Caracteristici
Buton cu trei pozitii: ON – functionare manual(continuu)
OFF- STOP oprit
AUTO – functionare pe baza comenzilor de la sonde
Modul de utilizare:
- control nivel minim
- control nivel maxim
- control prezenta lichid
- control lichid pentru 2 bazine
Specificatii modul:
Tensiune de alimentare: 220V AC
Iesire releu: 7A/220V (sarcina rezistiva)
3A/220V (sarcina inductiva)

Single-control UP pool (water storage) installation instructions shown in figure 1

A(red)-Upper water level control point. When water level gets to A point,
the probe touch water and controller can stop the pump by auto.
B(blue)-Lower water level control point. When water level gets off B point,
the probe out of reach water and controller can start the pump by auto.
C(black)-Should be placed in bottom of pool as the common line.
D(green) and E(yellow)are connected with C (black).

Single-control DOWN pool(drain water)installation instructions shown in figure 2.

E-Upper water level control point. When water level gets to E point,
the probe touch water and controller can start the pump by auto.
D-Lower water level control point. As liquid level gets off D point,
the probe out of reach water and controller can stop the pump by auto.
C-Should be placed in bottom of pool as the common line.
A&B-disconnected

Lack of water protection installation instructions shown in figure 3.

C&D-Lower water level control points. When water level gets off this point,
C or D probe out of reach water and controller can stop the pump by auto.
E&C-short-connected;
A&B-disconnected

Joint control UP and DOWN pool installation instructions shown in figure 4.

A-Upper water level control point in UP pool. When water level gets to A point,the probe touch water and controller can stop the pump by auto.
B-Lower water level control point in UP pool. When water level gets off A point, the probe out of reach water and controller can start the pump by auto.
C-Should be placed in bottom of UP and DOWN pools as the common line.
D-Lower water level control point in DOWN pool. When water level gets off D point, the probe out of reach and controller can stop the pump by auto.
E-Upper water level control point in DOWN pool. When water level gets to E point, the probe reach water and controller can start the pump by auto. Then pool starts to drain water. If not, E point disconnected

Pentru mai multe produse din oferta noastra va rog sa vizitati site ul www.dpelectronic.ro

Expediem cu CARGUS cu 19 ron pret fix, fara costuri suplimentare.
ATENTIE! pretul exprimat pentru serviciile de transport nu este in mod obligatoriu pretul final deoarece fiecare firma de curierat percepe taxe suplimentare in functie de greutate si KM exterior.
Expedierea produselor se va face in 1-2 zile lucratoare cu curierat si 2-4 zile cu posta romana, de la comanda.
Livrarea in termen de 1-2 zile lucratoare se aplica comenzilor plasate pana la ora 15:00.
Daca apare orice problema sau sunteti nemultumit sunati inainte sa acordati calificativ negativ si voi incerca sa rezolvam cu bine problema.